BKR® High-Quality Snow Tire Chains For Heavy Vehicles And Trucks CA0150 is the best-made snow chain that is fitted to the tire for icy roads. It comes in different sizes –
If you travel to the mountains or snowy areas regularly, sooner or later you’re going to have to use tire chains. Start by getting the right set for your vehicle at Jagan Hardware
1.)It comes for different tire size-275/70-16, 25/85-16, 265/75-16, 235/75-17.5, 25/70-17, 245/70-17.5, 245/75-17, 265/70-17, 265/70-18,275/60-18.
2.)It fits the tire easily and there is no need to retighten once it is installed.
3.)It is a simple and sturdy manual tensioning chain.
4.)It is very easy to use.
5.)Premium Quality 16mm Easily Adjustable snow chains For Different Tyre Sizes.
FROM THE MANUFACTURER
Carburizing Heat Treatment
After heat treatment, the hardness is higher than ordinary steel, the toughness is stronger, the effect is better.
Lock The Rubber Hook
Use excellent wire rope, strong durable, not easy to fall off, fixed tightening ring.
Provide Repair Chain
If the coloured cross rope breaks, it can be repaired with a repair chain.
High Strength Material
Resistant to the low temperature of minus 60 degrees Celsius keeps good performance in all weather.
Durable For Bad Situation
Even you stuck in sand, mud, snow, ice, climbing, or other emergent situations Your car will get more traction in a bad situation.
Without Damage for Tire
High Strength material keeps the tire in a good place without damage. perfectly protect the car tire in all weather.
Quick Installation
Snow chains include 2 pieces of chains and storage bags so that easy to carry and storage.
Easy Install follow the installation step.
Analysis of installation steps:
- STEP 1
- Spread the snow chains so that one end of the yellow plastic tube is on the left.
- STEP 2
- Rotate the snow chain to the inside of the tire so that the yellow plastic tube is on the right.
- STEP 3
- Connect the two-wire ropes tightly.
- STEP 4
- Use the yellow connecting chain to buckle into the green M-lock piece.
- STEP 5
- Slide the linked wire rope into the inside of the tire.
- STEP 5.1
- Schematic diagram of the inside of the tire
- STEP 6
- Pull tightly and hook the rubber hook to the yellow chain, the installation is complete when all the links are connected.
- STEP 6.1
- Connect according to the diagram as shown in pic
Note
- Any damage or loss caused by use or installation of the snowchains shall be sole responsibility of buyer. We request proper installation to be done and checked thoroughly slowly for some kms, so it doesn't loosen out and come out and cause any damages
- It is also important to deflate all tyres to maintain 11-15 psi pressure after installing snowchains.
- Jagan Hardware will not be responsible for any loss or damage arising out of use of these snowchains personal or physical to anyone or any thing. This product is part of experience under adventure sports and can be risky and fatal.
